Shenyang Water Pump Manufacturing Co., Ltd

Products

ISG series pipeline centrifugal pump

The ISG series pipeline centrifugal pump adopts the performance parameters of the IS type centrifugal pump and is cleverly combined and designed on the basis of the SG type pipeline pump. This series of products has the advantages of small footprint, comp

Phone:+8618765319799

E-mail:service@shenyangwaterpump.com

Product Category:Boiler feed pump

  • Product Details

Performance range

Flow rate: Q=5.4~400m3/h

Lift: H=4-125m

Model Description

Example: ISG200-315 (I) A (B, C)

ISG – Single stage single suction vertical pipeline centrifugal pump

200- nominal diameter of pump inlet and outlet (mm)

315- nominal diameter of impeller (mm)

I – Traffic classification

A. B and C – represent the outer diameter of the impeller after the first, second, and third cuts, respectively

application area

ISG series pipeline centrifugal pump is used for conveying clean water and other liquids with physical and chemical properties similar to water, with a service temperature of T ≤ 80 ℃. It is suitable for:

Industrial and urban water supply and drainage

Pressurized water supply for high-rise buildings

Landscape sprinkler irrigation

Fire pressurization

Long distance transportation

HVAC cold and hot water circulation pressurization and equipment matching

structure characteristics

The pump is a vertical structure with the same inlet and outlet diameters and is located on the same centerline. It can be installed in the pipeline like a valve, with a compact and beautiful appearance, small footprint, and greatly reduced construction investment.

The impeller is directly installed on the extended shaft of the motor, with a short axial size. The pump and bearing configuration is reasonable, which can effectively balance the radial and axial loads generated by the pump operation, thereby ensuring the smooth operation of the pump and low vibration noise.

The shaft seal is a mechanical seal made of hard wear-resistant alloy material, with a normal use time of over 8000 hours.

Easy installation and maintenance, without the need to dismantle the pipeline system. As long as the pump coupling seat is removed, all rotating parts can be extracted.

Working conditions

Maximum working pressure ≤ 2.5MPa (different pump models may vary)

The volume of solid insoluble matter in the suction and discharge medium shall not exceed 0.1% of the unit volume

The ambient temperature shall not exceed 40 ℃, the altitude shall not exceed 1000m, and the relative humidity shall not exceed 95%

Main component materials

The material of the overcurrent components is generally ordinary gray cast iron.

Complete range

A complete set of pumps, motors, common bases, couplings, etc. are supplied, as well as bottom valves, check valves, and gate valves.

Next:

Leave a Reply

Leave a message

    Home Tel. E-mail Add. Chat Menu